Broadcast SRC-32 Guía de instalación descargar pdf (Pagina 12)

GPI Install Guide

_____________________________________________________________________

ISA GPI-8 or GPI-16 Install for Windows NT or Windows 2000

A GPI-8 card will have a heavy gray cable with a molded female 37-pin

connector.

The GPI-16 uses the same instructions except where noted within the guide.

A GPI-16 will have two flat ribbon cables that attach to the card and

pass through a slot, out the back of the computer.

The connector port closest to the slot on the card is for GPI/O 1-8 while

the connector in the middle of the card is for GPI/O 9-16.

Here are the steps for installing an ISA GPI-8 or ISA GPI-16 card in Windows 2000.

IMPORTANT: One will need to set either the ISA slot or an IRQ within BIOS of the

machine to LEGACY. If one can not set this option, one will not be able to utilize the

ISA card within the operating system.

1. Open the COMMAND PROMPT.

Type and Enter: CD \ (This should give a C:\ prompt)

2. Type CD DAD\DRIVERS.NT\GPI then hit <ENTER>.

3. Type EDIT DADPIO.INI then hit <ENTER>.

4. Find the line (third from the bottom)

IoPortCount = REG_DWORD 0x00000004

For a GPI8, leave this line alone. Go to step 6.

GPI16 NOTE:

For a GPI16, change this line as shown below:

IoPortCount = REG_DWORD 0x00000008

5. Save and Exit this file.

6. From the DOS Prompt again, Type AUTOINST C:\DAD then hit <ENTER>.

This will flash then close the window.

7. Start up DAD.

8. After DAD has loaded. Go to SETUP and select README.

9. Open the workstation’s CFG file. (Top left button in white)

10. Towards the bottom of the file, find the line REMOTE = 0.

Change this line to read: REMOTE = 300

Also, find the line GPO_GPI = 0 0 0 and change it to GPO_GPI = 8 8 16

GPI16 NOTE:

For a GPI 16, set the line to: GPO_GPI = 16 16 32

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Broadcast SRC-32 Guía de instalación Pagina 12