Broadcast SRC-32 Guía de instalación descargar pdf (Pagina 3)

GPI Install Guide

_____________________________________________________________________

8. Type and enter: EDIT DADPIO.INI

9. Find the line:

IoPortAddress = REG_DWORD 0X00000300

Change the last four digits of the line to the address found in the above steps.

For example: IoPortAddress = REG_DWORD 0X0000A000

GPI-16 NOTE:

For a GPI-16 one must also modify the line:

IoPortCount = REG_DWORD 0x00000004

Change the last digit of the line to ‘8’

For example: IoPortCount – REG_DWORD 0x00000008

10. Save and exit this file.

11. From the DOS Prompt again, Type AUTOINST C:\DAD then hit <ENTER>.

This will flash; then close the window.

12. Start up DAD. After DAD has loaded. Go to SETUP and then select CFI & README

and open the workstation’s CFI file. (Top left button in white)

13. Scroll down towards the bottom of the file and find the line REMOTE = 0.

Modify this line to: REMOTE = PCI “Your Address” oicx

(Example) REMOTE = PCI A000 oicx

GPI-16 NOTE:

If a GPI-16 is being installed, one should modify this line to:

REMOTE = PCI “Your Address” oicxoicx

(Example) REMOTE = PCI A000 oicxoicx

14. Find the line GPO_GPI = 0 0 0 and change it to GPO_GPI = 8 8 16

GPI-16 NOTE:

If a GPI-16 is being installed, one should modify this line to:

GPO_GPI = 16 16 32

15. Save the changes and close the file. Hit the yellow REFRESH Button, then EXIT

DAD. Once DAD has exited, reboot the PC.

To test the card, start DAD, open the LIBRARY, open the COMMAND window and type

the line PULSE GPO 1 1000 and hit EXECUTE. This will send a relay from DAD to

GPO 1. One should be able to hear a “click” on the card itself when the relay opens,

then closes.

If you would like an Install file to prevent Windows from wanting to install a ‘New Device’ you can

use and install the following INF file

ftp://ftp.enco.com/pub/drivers/GPI/CBI95.INF

1 2 3 4 5 6 7 8 ... 17 18

Sin comentarios

Broadcast SRC-32 Guía de instalación Pagina 3