Broadcast SRC-32 Guía de instalación descargar pdf (Pagina 6)

GPI Install Guide

_____________________________________________________________________

PCI GPI-8 or GPI-16 Install for Windows XP

Here are the steps for installing a PCI GPI-8 or a GPI-16 in Windows XP.

NOTE: The GPI card should be physically installed after the Instacal software has been

installed on the workstation.

1. Install the Instacal Software that was provided with the card. If the software is not

available, it can be downloaded at:

http://www.computerboards.com/download.htm

2. Shutdown the PC and install the PCI GPI-8 or GPI-16 card into an available PCI

slot. Restart the machine after the card has been installed.

3. Microsoft Windows will automatically detect the card and start the Install Wizard.

Allow the Install Wizard to automatically detect the card. Follow the prompts for the

Wizard until finished.

4. After the Wizard has completed, run the Instacal program.

[START>PROGRAMS>COMPUTER BOARDS>INSTACAL]

The program will find the new card.

5. Double-click on the new card it has found. It will display an

IO address on the left-hand side in a grayed out box. Make

note of the address, then close the Instacal program.

6. Open the COMMAND PROMPT and enter CD \ (This will

take you to the C:\ prompt)

7. Type and enter: CD DAD\DRIVERS.NT\GPI

As of DAD version 5.0+ the path to enter is: CD DAD\DRIVERS\GPI

8. Type and enter: EDIT DADPIO.INI

9. Find the line (tenth from the top)

IoPortAddress = REG_DWORD 0X00000300

Change the last four digits of the line to the address found in the above steps.

For example: IoPortAddress = REG_DWORD 0X0000A000

GPI-16 NOTE:

For a GPI-16 one must also modify the line:

IoPortCount = REG_DWORD 0x00000004

Change the last digit of the line to ‘8’

For example: IoPortCount – REG_DWORD 0x00000008

10. Save and exit this file.

11. From the DOS Prompt again, type and enter: AUTOINST C:\DAD

This will flash then close the window

12. Uninstall the Computer Board software. This is done from START > SETTINGS >

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Sin comentarios

Broadcast SRC-32 Guía de instalación Pagina 6